How To Cut Laminate Properly

Introduction

The usage of laminate as a flooring material is widespread. This covering is excellent for flooring since it is waterproof and long-lasting. Another advantage is that it is possible to prepare and then install the laminate sheets at your home without the assistance of a professional if you have certain do-it-yourself tools.

However, because laminate is fragile, cutting it takes more caution and care. With the help of this instruction, you will learn  How To Cut Laminate With Simple Methods and get the best finish using a variety of equipment.

How To Cut Laminate

• Handheld Powered Saw

Because handheld power saw cuts on the upstroke, the best way to reduce the likelihood of chipping is to place the face of the laminate sheet down and make your Cutting Laminate  from the back of this sheet. Constructing a jig or guide is the greatest way to assure that a cut will be straight.

Putting the sheet down on a worktable, remember to place the offcut which is hanging over the edge. After that, clamping a piece of straight hardwood to that table is a straightforward method for achieving this result. It needs to be shifted away from the path of cut by a length equal to that which separates the saw foot's edge from the blade's closest edge.

• Jigsaw

Specialty cuts, such as those needed to access air conditioning or heating ducts in the floor, are best made with a jigsaw, which is also useful for crosscuts and rips.

However, keep in mind that the jigsaw will operate considerably slower than a miter or circular saw, and that it will often run through a fair number of blades.

Laminate flooring may be cut with a jigsaw using a fine or medium-toothed blade; just be sure the cut side is facing up.

If you find that the metal base of your jigsaw is scratching the workpiece, you may easily apply a couple of strips of tape to it to avoid further damage.

See Page:

Cutting Laminate sheets

How to cut Laminate

• Table Saw

It is common practice for installers to use a table saw for cutting large sheets down to manageable sizes, but this needs the sheet to be supported not just on the cutting side but also on the out-feed face. The fence's alignment with the saw's blade has to be precise.

Pieces should be oversized to account for chipping, yet there are 2 ways to reduce the appearance of wear and tear. The first way is to feed the sheet facing up through this saw, and the second way is to place the blade in reverse, however, this should only be done by experienced someone with prior table saw knowledge.

Conclusion

If you want to cut and install laminate floors at your home, one of the skills you need to have is the ability to cut laminate sheets. We hope that by reading this guide, you now have a better understanding of what steps to take. Collect the necessary equipment, and be sure to pay great attention to the instructions. It won't take you long to figure it out.

In case you are still not sure about cutting laminate sheets properly, read  Joseph French's article on TheKingLive to have a more comprehensive guide.